WIRE/ROD CALIBRATION EQUIPMENT AND LINES

 

 

BLANK FEEDING MECHANISM

 

Basic set of equipment for blank feeding mechanism includes a coil holder for rolled wire; extra equipment includes a mechanism for rolled wire end unbending and hydraulic-type prolonged equipment (available for 18 mm diameter wire).

Blank feeding mechanism Straightening equipment Equipment for metal dephosphorization Drawing machines Catheter Polishing machine Unloader
Blank feeding mechanism Straightening equipment Equipment for metal dephosphorization Drawing machines Catheter Polishing machine Unloader

 

COIL HOLDER FOR ROLLED WIRE

 

coil2

coil1
fig. 1. fig. 2.

Coil holder for rolled wire can be installed directly on a flat surface or designated at an angle of 90 degrees

  • Rotating coil holder for rolled wire with one coil (fig. 1)
  • Load capacity: 3 t/coil
  • Voltage: 380V, 50Hz
  • Rotating coil holder for rolled wire with two coils (fig. 2)
  • Load capacity: 2 3 t/coil
  • Dimensions: 3500(L) х 2300(W) х 3572(H)
  • Voltage: 380В, 50Гц

 

MECHANISM FOR ROLLED WIRE END UNBENDING

HYDRAULIC-TYPE PROLONGED EQUIPMENT

coil opener thrust gear

Mechanism for rolled wire end unbending is able to quickly and easily pull the end of the large-diameter rolled wire. The curved part is forwarded directly to the board.

The principle of prolonged equipment based on the use of hydraulic power, leading the rolled wire to drawing machine (available for 18 mm diameter wire).